Type RS-2 – Torelin

Type RS - 2

The width of the clamp should be at least equal to the pipe OD.
The width of the clamp should be 150 mm greater than the length of any crack on pipes with an outside diameter up to 350 mm. On larger pipes this should be at least 200 mm.
For PVC pipes, the width of the clamps should be 50 % longer and bolt torque should be reduced by 50 %.
The maximum allowable distance between two pipe ends should not exceed 10 mm.
The maximum allowable deﬂection is 2 degrees.
The maximum allowable offset should not exceed 3 mm.

All metal parts: stainless steel AISI 304.
Metal parts have been deburred and are passivated to restore the corrosion resistance to its original state after the welding process.
Double band (two sections) with a working range of 20-22 mm depending on the diameter.
Standard certiﬁed rubber gaskets EPDM or NBR. The rubber is tapered and has a waffle pattern.
Seamless rubber lining for every clamp diameter.
Bridge plates are vulcanized into the rubber gasket.
U-shaped lifter bar.
Stainless steel, electrolytic zinc plated nuts to prevent galling.
Stainless steel washers.
No loose parts that may get lost during installation.
No special tools required: a simple wrench will do the job.
Special tape is used to ﬁx the rubber gasket to the stainless steel band. This tape is ﬂexible and reinforced with glass ﬁbre thread to withstand hot and humid conditions and guarantee a long storage capability.
Under most circumstances the clamps can be installed without releasing the pressure on the pipe.
The clamps are packed into strong double-rib cartons. For export overseas we use strong, seaworthy crates.